LOGIN
MENU
APM Engineering Co., LTD.
| Product Categories | Health at work |
| Country | Korea, South |
| Address | (14502) Bucheon Techno Park Complex 2, Building 202, Room 808 388, Songnae-daero, Bucheon-si, Gyeonggi-do, Korea |
| Tel | +82-32-219-7700 |
| Website | http://www.apm.co.kr |
COMPANY INTRODUCTION
APM Engineering was established in March 1994 to contribute to the advancement of the domestic air environment measurement and analysis field. For 27 years, we have been striving for the development of the domestic air environment measurement field through technological exchanges with leading overseas measurement equipment and analyzer manufacturers and independent domestic technology development. In particular, we are making efforts to publicize the importance of respirators fit-testing in
Our Products
Personal Aerosol Monitor
□ Explosion-proof type and can be used in dangerous areas
□ Smart battery system allows you to check the remaining battery time
□ High-capacity battery for more than 20 hours
□ Small and lightweight, easy to carry while working
□ 95 dBA alarm and warning screen
Respirator Fit Tester(PortaCount Pro)
□ Safety and Health Agency H-82 Respirator Selection,Use, and Adaptation Appropriate Equipment for Management
□ Equipment suitable for inspection of respirator adhesion in the Ministry of Food and Drug Safety’s ‘Medical Respirator Approval Review Guidelines’
□ Airtightness measurement of N95mask
Automated Filter Tester
□ Equipment conforming to the medical mask test standard
□ NaCl and Oil Test available
□ High sensitivity and resolution (99.9999% transmittance measurement)
□ Consistent test results
□ Fully automated interface
□ Easy equipment operation
Mask Integrity Test Accessory
□ Mask and respirator integrity (Protection Factor) test
□ Exhalation Valve and Drink Tube included
□ Convenience of testing using Aerosol Generator and Wand
□ Using a head model, a test that is safe from harmful gases
Optical Particle Sizer(OPS)
□ 0.3 ~ 10 μm particle size range
□ Measurement of mass concentration and number of particles using 16 channels
□ Determination of particle mass concentration using particle density and refractive index
□ High concentration measurement conditions possible (275 mg/m3)
□ Measure mass concentration by attaching a 37 mm filter
Portable Black Carbon Monitor
□ The device is very easy to operate and carry
□ Measurement of absorption rate of single wavelength of 880nm
□ Measurable with a resolution of 0.001 μg
□ Built-in battery for more than 24 hours
PM2.5 Sampler
□ Collecting TSP, PM10 and PM2.5 in the atmosphere and indoor air
□ Operation of equipment to measure the mass concentration of fine dust
□ Analysis of fine dust containing organic and inorganic substances in the atmosphere
□ PM10 monitoring in the evaluation area according to the environmental impact assessment
OFF-LINE Website GO